Lumibricks Moon Bar 18009

Coastal Build: Before the Glow

The Moon Bar stands raw, its plate-on-plate foundation promising solid structural integrity against any imagined coastal storm. Each level, a sturdy sub-assembly, awaits the vibrant story the light points will tell. Beside it, a greebled off-road vehicle, packed for adventure, silently anticipates its illuminated role in this beachside narrative. This is the calm before the glow.

Lumibricks
$140.39
Original
$155.99
10% off code:
⚡ 24 Light Points 100% Pad Printed (No Stickers)
Set # 18009
Released 2026
Pieces 2186
Price / Piece 7.1¢
Figures 5
Age 16+
More at Lumibricks

We may earn a small commission from qualifying purchases at no extra cost to you.

Set 18009 Build Specifications & Overview

Complete build timeline, spatial dimensions, and display footprint analysis.

Value Breakdown

Est. Build Time (*Pieces per minute)
Casual 20.9h 2 ppm*
AFOL (Avg) 11.8h 4 ppm*
Master Builder 7.9h 7 ppm*
⚡ Includes approx. 2.7 hours of dedicated micro-LED wire routing.
Tweezers are highly recommended for this phase.
Avg Price / Hour
$13.22/hr
Specialty Part Value
Minifigures (5) $25.00
Specialty Tools
Precision Tweezers $2.50
Brick Separator $1.50
Illumination Breakdown
Light Points (24 × $1.00) $24.00
Light Strips (11 × $2.00) $22.00
Power Hub & Cables (Flat) $3.00
Specialty Total $78.00
Price Per Basic Brick
$0.04

Highly valuable! 49% cheaper than average Lumibricks sets.

Display Dimensions

Height 10.1 in (25.7 cm) 26 Bricks + 2 Plates high
Width 12.3 in (31.2 cm) 39 Studs wide
Depth 10.1 in (25.7 cm) 32 Studs deep
Display Footprint 124.2 sq in (801.3 sq cm) 39 × 32 Studs
Weight 9.70 lbs (4.4 kg)

The Scale Check

Height equivalent to approx 6.4 minifigures stacked.

Display Fit
Standard Shelf Friendly (Kallax/Billy)

Illumination Specs

Tweezers Included 100% Pad Printed
Illumination Density
16.01

Light sources per 1,000 pieces. ↑ 1x higher than average.

Hardware Blueprint
Light Points (Micro-LEDs)
24
Light Strips
11
Power Modes Supported
usb cable, battery case
Power Requirements
Requires 3x AAA (1.5V), 2x CR2032 (3V) Not Included

Video Showcase